Suzuki Baleno Manual page 475

1. Differential assembly
2. Transmission right case
3. Speedometer driven gear assembly
1. Input shaft oil seal
2. Countershaft R bearing cup
1. Gear shift arm
2. Gear shift shaft
RIGHT CASE
1) Remove differential gear assembly from right case.
2) Remove bolt and then pull out speedometer driven gear.
CAUTION:
Be careful not to damage speedometer driven gear
case when removing it.
3) Remove input shaft oil seal by using special tools (combination
of bearing remover and sliding shaft).
Special Tool
(A): 09930-30104
(B): 09923-74510
4) Also pull out countershaft R bearing cup by using bearing re-
mover 09941-64511 with sliding shaft 09930-30104.
NOTE:
If input shaft R bearing has been left in right case, pull it out
by using bearing remover 09923-73210 with sliding shaft
09930-30104.
5) Remove bolt and then pull out gear shift arm.
3. Bolt
6) Remove gear shift shaft bolt with washer, then take out spring
and steel ball.
7) Remove gear shift shaft, boot and oil seal.
8) Remove differential side R oil seal from right case.
1. Gear shift shaft
2. Boot
3. Oil seal
4. Gear shift shaft
bolt
5. Washer
6. Spring
7. Ball
MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS) 7A-19