Suzuki Baleno Manual page 663

INSTALLATION
1) Install 2nd brake piston.
i) Put piston spring in transmission case and insert piston as-
1. Seal
2. Seal ring
ii) Install piston cover to case after applying fluid to 2 cover
iii) Push down piston cover by using valve lifter with 17 mm
1. Cover seal (O-ring)
AUTOMATIC TRANSMISSION (3 A/T) 7B-93
sembly into case after applying fluid to piston rod, seal and
seal ring.
seals.
socket and install snap ring. Refer to step 13) of "DIS-
ASSEMBLY" in this section.
1. Second brake band
2. Pin
3. Piston cover snap ring
4. Piston cover
5. Cover seal (O ring)
6. Retainer (E ring)
7. Seal ring
8. Second brake piston
9. Piston seal
10. Piston spring
11. Brake rod spring
12. Washer
13. Piston rod seal (O ring)
14. Second brake piston rod
15. Cover gasket
16. Cover