Suzuki Baleno Manual page 302

4-8 FRONT DRIVE SHAFT
1. Snap ring
6) Apply grease to entire surface of cage.
Use joint grease in tube included in differential side boot set or
DOJ set of spare parts.
7) Insert cage into outer race and fit snap ring into groove of outer
race.
CAUTION:
Position opening of snap ring "c" so that it will not
be lined up with a ball.
8) Apply grease to inside of outer race, and fit boot to outer race.
9) Fitting boot to outer race, adjust so that measurements "d" and
"e" become as indicated in figure.
[1.3 L and 1.6 L engine model]
Length "d": 162.5 mm (6.40 in.)
"e": 196.5 mm (7.74 in.)
[1.8 L engine model]
Length "d": 171.5 mm (6.75 in.)
"e": 193.0 mm (7.60 in.)
Before fixing boot band, insert screwdriver into boot on outer
race side and allow air to enter boot so that air pressure in boot
becomes the same as atmospheric pressure.
10) Fixing boot band.