Suzuki Baleno Manual page 674

7B-104 AUTOMATIC TRANSMISSION (3 A/T)
1. Direct clutch 3. Input shaft
2. Straightedge A: Straightedge width
38) Measure input shaft position.
Seated position of input shaft can also be measured after
installing case housing as distance "c" (Measured straight-
edge width A), and it should be188.37 – 189.91 mm (7.416 –
7.477 in.).
Distance "C": 188.37 – 189.91 mm (7.416 – 7.477 in.)
39) Install input shaft bearing race and bearing on input shaft.
Grease bearing race and install it with its flange side outward
together with bearing.
Install so that bearing does not get on bearing race flange.
"A": SUZUKI SUPER GREASE C, 99000-25030
1. Race
2. Bearing
40) Install another input shaft bearing race on oil pump.
Grease bearing race and attach it to oil pump body.
NOTE:
D With this bearing race, input shaft thrust play is ad-
D Make sure seal rings are installed in pump cover flange
"A": SUZUKI SUPER GREASE C, 99000-25030
1. Race
41) Attach greased direct clutch washer on oil pump.
Fit washer flange into notch of oil pump body.
"A": SUZUKI SUPER GREASE C, 99000-25030
1. Washer
2. Notch for washer
flange
42) Install greased new oil pump cover seal (O ring) in outer
groove of oil pump.
Make sure that cover seal is not twisted or extruded.
justed. Refer to step 44) for measuring procedure.
in good condition lubricated with automatic transmis-
sion fluid.