Suzuki Baleno Manual page 1003

1. Door mirror garnish 4. Door trim
2. Clip 5. Inside handle assembly
3. Trim mounting screw
1. Grass bottom channel 2. Screw
1. Bottom channel
2) Remove door mirror garnish, clips, and door trim mounting
screw.
3) Remove inside handle assembly mounting screw, and remove
inside handle assembly from door trim by sliding it forward.
4) Remove door trim.
5) Disconnect power window switch coupler (if equipped).
mounting screw
6) Remove door grip stay.
7) Remove door sealing cover.
8) Remove glass bottom channel attaching screws.
9) Take out door glass together with bottom channel.
10) Detach glass from bottom channel.
INSTALLATION
Reverse the removal procedure for installation, and then noting the
following instructions.
When installing glass to bottom channel, coat channel with soap
water and tap it with a plastic hammer.
Glass-fitted position of bottom channel is as shown in figure.
Length "a"
Adjust equalizer of window regulator so that measurements A
and B in figure are equal to each other.
1. Screw
Hatch-back model 197 – 200 mm (7.75 – 7.85 in.)
Sedan model 232 – 236 mm (9.15 – 9.25 in.)
BODY SERVICE 9-3