Suzuki Baleno Manual page 292

3G-24 SUSPENSION CONTROL SYSTEM
1. Ohmmeter
2. Mode selector switch coupler
3. Mode selector switch
1. Absorber adjusting actuator
2. Actuator coupler
MODE SELECTOR SWITCH
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Remove mode selector switch from parking brake cover.
3) Disconnect mode selector switch coupler.
1. Screw driver
2. Selector switch
INSPECTION
Check continuity between mode selector switch terminals.
Mode selector switch position
If check result is not as specified, replace mode selector switch.
INSTALLATION
1) Connect mode selector switch coupler.
2) Install mode selector switch to parking brake cover.
3) Connect negative (–) cable to battery.
BRAKE LIGHT SWITCH
Refer to Section 5.
ABSORBER ADJUSTING ACTUATOR
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect actuator coupler.
3) Remove absorber actuator by removing its mounting screws.
AUTO
SPORT
Ohmmeter indicator
infinity
continuity