Unit Repair Overhaul; Dismounting Of Transmission; Under Hood - Suzuki Baleno Manual

7A-14 MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS)
1. Control shaft bolt
2. Gear shift shaft 4. Gear shift control shaft
3. Extension rod nut 5. Extension rod
1. Drive shaft joint
2. Screwdriver
1. Drive shaft
2. Center bearing support

UNIT REPAIR OVERHAUL

DISMOUNTING OF TRANSMISSION

UNDER HOOD

1) Disconnect battery ground cable.
2) Remove clutch cable joint nut, joint pin from cable and then
3) Undo wiring harness clamps and couplers.
4) Remove transmission fastening bolts.
5) Remove starter taking out its 2 bolts. Starting motor plate
6) Remove exhaust manifold cover.
7) Remove exhaust No.1 pipe nuts.
ON LIFT
1) Drain transmission oil.
2) Remove engine under cover of left side.
3) Remove exhaust No.1 pipe.
4) Remove gear shift control shaft bolt and nut, then detach con-
5) Remove extension rod nut and then pull out rod with washers.
6) Remove clutch housing lower plate.
7) Remove ball stud bolt from right and left knuckles, then discon-
8) By using large size screwdrivers, pull out drive shaft joints at
9) Remove center bearing support bolts and pull out center drive
10) Remove transmission stiffener.
11) Remove transmission to engine bolt and nut.
12) Remove engine rear mounting bracket bolts.
13) Lower vehicle and support transmission with transmission
3. Bolt
cable itself from bracket.
should also come down.
trol shaft from gear shift shaft.
Disconnect stabilizer joint from suspension arm.
nect each suspension arm.
differential side so as to release snap ring fitting of joint. (for LH
drive shaft).
shaft from differential gear. (for RH drive shaft).
jack.