Suzuki Baleno Manual page 805

3) Remove No.3 clutch discs and clutch plates in the following or-
der.
(1) Disc " (2) Plate " (3) Disc " (4) Plate
4) Remove reverse clutch return spring by removing snap ring, us-
ing special tool and hydraulic press.
Special Tool
(A): 09926-96010
NOTE:
To prevent deformation of spring seat, it is recommended
to compress spring seat until claw section of snap ring is
1. Reverse clutch
free.
return spring
2. Press
5) Mount reverse clutch drum with bearing to oil pump body.
6) Remove reverse clutch piston by blowing compressed air
(400 – 800 kPa, 4 – 8 kg/cm
tion "A".
7) Remove two O-rings from piston.
NOTE:
Never reuse removed O-rings.
1. Reverse clutch piston
INSPECTION
1) Check that sliding surfaces of disc and plate are not worn or
burnt. If necessary, replace.
NOTE:
D If disc lining is exfoliated or discolored, or part of printed
D Before assembling new discs, soak them in A/T fluid for
2) Measure height of reverse clutch return spring.
Specified value: 18.7 mm (0.74 in.)
NOTE:
Do not apply excessive force when measuring spring
height. Perform measurement at several points.
numbers ("A" section) is defaced, replace all discs.
at least two hours.
AUTOMATIC TRANSMISSION 7B1-121
2
, 57 – 113 psi) through oil hole sec-