3B1-30 POWER STEERING (P/S) SYSTEM
9) Apply power steering fluid to each vane.
10) Install vanes (10 pieces) to rotor.
1. Rotor
2. Vane
11) Apply power steering fluid to O-ring.
12) Install O-ring to pump body.
1. O-ring
13) Apply power steering fluid to sliding surface of pump cover and
rotor.
14) Match the dowel pins to the holes of the cover plate as shown
and install pump cover to pump body.
1. Dowel pin
2. Cover plate
15) Gradually tighten pump cover bolts to specified torque.
NOTE:
After installing pump cover, check to make sure that shaft
can be turned by hand.
Tightening Torque
(a): 28 N
1. Pump cover
.
m (2.8 kg-m, 20.0 lb-ft)