Remove And Install Stabilizer Bar And/Or Bushings - Suzuki Baleno Manual

3D-4 FRONT SUSPENSION
ON-VEHICLE SERVICE
REMOVE AND INSTALL STABILIZER BAR
AND/OR BUSHINGS
REMOVAL
1) Remove stabilizer link nuts, washers and cushions.
When loosening link nut, hold stud with wrench.
2) Remove stabilizer mount brackets.
3) Remove stabilizer.
4) Remove stabilizer joints from stabilizer.
When loosening joint nut, hold stud with wrench.
INSTALLATION
1) Loosely assemble all components in reverse order of removal.
2) With painted mark on stabilizer bar and end face of mount bush-
ing aligned, tighten mount bracket bolts to specified torque.
NOTE:
If painted mark has gone, align the vehicle center and the
center of stabilizer bar.
Tightening Torque
1. Mount bush
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
2. Painted mark
3) Tighten each nut to specified torque.
When tightening, hold stud with wrench.
Tightening Torque
(b): 50 N·m (5.0 kg-m, 36.5 lb-ft)
(c): 28 N·m (2.8 kg-m, 20.5 lb-ft)
1. Stabilizer bar
2. Mount bush
3. Mount bracket
4. Joint
5. Joint nut
6. Link washer
7. Link cushion
8. Centering washer
9. Mount bolt
10. Link nut