Suzuki Baleno Manual page 242

11) Upon completion of all jobs, depress brake pedal with about
30 kg (66 lbs) load three to five times so as to obtain proper
drum-to-shoe clearance.
Adjust parking brake cable. (For adjustment, see SECTION
5.)
12) Tighten parking brake lever cover screws.
13) Install wheel and tighten wheel nuts to specified torque.
14) Check to ensure that brake drum is free from dragging and
proper braking is obtained.
15) Lower hoist and bounce vehicle up and down to stabilize sus-
pension.
16) Tighten control rod outer bolts and trailing rod rear bolt to spe-
cified torque with vehicle weight on suspension.
Tightening Torque
(d): 90 N·m (9.0 kg-m, 65.0 lb-ft)
Then check toe.
17) Perform brake test (foot brake and parking brake).
18) Check each installed part for fluid leakage.
REAR SUSPENSION (2WD VEHICLE) 3E-19