Suzuki Baleno Manual page 758

7B1-74 AUTOMATIC TRANSMISSION
Throttle pressure control solenoid.
1. Oiler
2. Solenoid valve A: Hole (Should be dry)
3. Battery B: Exhausting fluid
INSPECTION
Shift solenoid No.1
Shift solenoid No.2
Resistance Check
TCC solenoid.
Shift solenoid No.1 and No.2 and TCC solenoid
Check resistance between terminal and solenoid body.
Standard resistance: 11 – 15 W at 20 C, 68 F
Throttle pressure control solenoid
Check resistance between each terminals.
Standard resistance: 3 – 5 W at 20 C, 68 F
Operation check
Shift solenoid valves No.1 and No.2.
1) Apply oiler to solenoid valve and give compression by hands
and then check to be sure that transmission fluid from oiler does
not come out of holes in solenoid valve when battery voltage is
not conducted.
2) Under the same conditions as above, conduct battery voltage
and then make sure that fluid comes out with vigor.
If check result is not as described, replace shift solenoid valve.