Suzuki Baleno Manual page 376

[2WD vehicle]
[4WD vehicle]
[2WD/4WD vehicle]
1. Spindle or drive shaft nut
2. Caulked
3) Install parking brake cable to brake plate.
1. Brake back plate
2. Cable stopper ring
3. Brake cable
4) Install wheel cylinder, and tighten wheel cylinder bolts and
brake pipe flare nut to specified torque by referring to steps 1)
to 4) of "INSTALLATION" under "REMOVE AND INSTALL
WHEEL CYLINDER" in this section.
5) Install brake shoes, referring to steps 1) and 2) of "INSTALLA-
TION" under "REMOVE AND INSTALL BRAKE SHOE" in this
section.
6) Install wheel hub assembly, washer and new spindle nut (new
1. Wheel hub
drive shaft nut).
2. Spindle nut
For 2WD vehicle, perform Steps 4) to 7) of "INSTALLATION" un-
der "REMOVE AND INSTALL WHEEL HUB (WHEEL BEAR-
ING) ASSEMBLY AND WHEEL STUD (HUB BOLT)" in Section
3E.
For 4WD vehicle, perform Steps 3) to 7) of "INSTALLATION" un-
der "REMOVE AND INSTALL WHEEL HUB, WHEEL STUD/
WHEEL BEARING OUTSIDE INNER RACE" in Section 3E1.
1. Brake drum
2. Drive shaft nut
7) For procedure hereafter, refer to steps 7) to 12) of "INSTALLA-
TION" under "REMOVE AND INSTALL WHEEL CYLINDER" in
this section.
BRAKES 5-51