Suzuki Baleno Manual page 301

1
1. Drive shaft 2. Cage
3) Remove bearing support circlips.
4) Remove center bearing from center bearing support.
1. Circlip
REASSEMBLY (Drive Shaft)
1) Wash disassembled parts (except boots). After washing, dry
parts completely by blowing air.
2) Clean boots with cloth. Do not wash boots in degreaser, such
as gasoline or kerosene, etc.
Washing in degreaser causes deterioration of boot.
3) Install boot onto drive shaft till its small diameter side fits to shaft
groove and fix there with boot band.
1. Boot
2. Boot band
4) Drive in the cage by using a pipe whose inner diameter is 23 mm
(0.906 in.) or more and outer diameter is 32 mm (1.260 in.) or
less.
Diameter "a": 23 mm (0.906 in.) or more
Diameter "b": 32 mm (1.260 in.) or less
CAUTION:
Install cage directing smaller outside diameter side to
shaft end.
3. Pipe
5) Install circlip by using special tool (A).
Special Tool
(A): 09900-06107
1. Circlip
FRONT DRIVE SHAFT 4-7