Suzuki Baleno Manual page 670

7B-100 AUTOMATIC TRANSMISSION (3 A/T)
20) Push one-way clutch race snap ring into place by hand.
Visually check to make sure that ring is fully seated.
Also, make sure that ends of snap ring are between lugs.
21) Install sun gear pin and thrust washer on sun gear assembly.
Apply grease to thrust washer so that it will not fall off.
Check to make sure that pin is fitted in thrust washer notch.
"A": SUZUKI SUPER GREASE C, 99000-25030
1. Sun gear pin
2. Thrust washer
3. Notch
22) Push in sun gear assembly while engaging it with rear plane-
tary gear. Be careful not to damage bushing inside sun gear.
After installing sun gear, check thrust washers for proper
installation by moving sun gear up and down lightly with finger.
If sun gear makes clear sound like "Click" when moved up and
down, washers are installed in place. But if no sound or thick
one is heard, it is possible that they are out of places. In such
case, remove sun gear and check.
23) Install front planetary gear bearing and race to sun gear in the
following order.
i) Bearing
ii) Race (flange side down)
Refer to "ASSEMBLING UNIT" in this section for installation.
24) Install front planetary gear assembly while turning it back and
forth. After installing front planetary gear assembly, check
bearing and race installed in step 23) for proper installation by
moving planetary gear assembly up and down lightly with fin-
ger. If planetary gear makes clear sound like "Click" when
moved up and down, bearing and race are installed in place.
But if no sound or thick one is heard, it is possible that they are
out of place. In such case, remove planetary gear assembly
and check.