Suzuki Baleno Manual page 1024

9-24 BODY SERVICE
[A]
[B]
[A] [B]
Rubber sucker grip attached outside
[A]: Hatch-back model
[B]: Wagon model
[A] [B]
[A]: Hatch-back model
[B]: Wagon model
7) Using new brush, apply sufficient amount of primer for molding
(urethane) to surface "A" as shown in figure.
8) Apply adhesive as shown.
NOTE:
9) Peel remaining paper from molding.
[A]: Hatch-back model
[B]: Wagon model
1. Molding
2. Adhesive tape
3. Adhesive
4. Glass
10) Attach rubber sucker grip to outside of glass.
Use of a rubber sucker grip is helpful to hold and carry glass
after adhesive is applied.
11) For Hatch-back model:
Press glass against body so that clearance "e" and "f" as
shown below.
Clearance:"e": approximately 4.6 mm (0.20 in.)
Clearance:"f" : approximately 5.5 mm (0.25 in.)
For Wagon model:
Press glass against body so that clip hole in body matches with
clip position on glass.
Start from bottom side "B" of glass.
As for rear side "C" of glass, apply adhesive so that
shape of the adhesive applied part matches shape of
primer coated part of body (as in step 2)).
Height "a" : Approximately 16 mm (0.63 in.)
Width "b" : Approximately 9 mm (0.35 in.)
Width "c" : Approximately 2 mm (0.08 in.)
Width "d" : Approximately 3.5 mm (0.14 in.)
Width "e" : Approximately 9.5 mm (0.37 in.)