Suzuki Baleno Manual page 213

3D-14 FRONT SUSPENSION
1. Strut 3. Ball stud
2. Knuckle 4. Suspension arm
REMOVE AND INSTALL KNUCKLE/BEARING
REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove wheel hub. Refer to Step 2) – 8) in WHEEL HUB RE-
MOVAL of this section.
3) Disconnect tie-rod end from knuckle with special tool (A).
Special Tool
(A): 09913-65210
1. Tie-rod end
2. Knuckle
4) Remove ABS wheel speed sensor from knuckle. (If equipped)
5) Remove strut bracket bolts from strut bracket and then ball stud
bolt.
6) Remove knuckle.
INSTALLATION
1) Install knuckle to ball stud on suspension arm and strut bracket.
Installing direction of each bolt is as shown. Align knuckle bolt
FORWARD hole with ball stud groove as shown and install ball stud bolt.
Tighten each nut to specified torque. (Refer to next page.)
2) Install ABS wheel speed sensor to knuckle, if equipped. Tighten
sensor bolt to specified torque.
Tightening Torque
23 N·m (2.3 kg-m, 17.0 lb-ft)
NOTE:
Check to make sure that ABS wheel speed sensor tooth is
free from any metal particles.
1. Knuckle
2. Ball stud
3. Suspension arm