Suzuki Baleno Manual page 465

1. Drive shaft
2. Center bearing support
1. Steering knuckle
2. BaIl stud bolt
3. Link nut
4. Lower arm
MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS) 7A-9
6) Insert drive shaft joint or center drive shaft to differential gear.
With right side drive shaft, install center bearing support.
CAUTION:
D Be careful not to scratch oil seal lip with drive shaft
joint while inserting.
D Make sure to insert drive shaft joint fully and seat its
snap ring as it was.
D Do not hit joint boot with hammer or the like. Noth-
ing but hands is allowed to use when inserting joint.
Tightening Torque
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
7) Connect ball stud with knuckle and fasten with bolt to specifica-
tion.
Tightening Torque
(b): 60 N·m (6.0 kg-m, 43.5 lb-ft)
8) Install stabilizer bar to suspension arm and fasten link nut to
specification.
Tightening Torque
(c): 28 N·m (2.8 kg-m, 20.5 lb-ft)
9) Fill transmission oil as specified and make sure that oil has been
sealed with oil seal.