Suzuki Baleno Manual page 825

DIFFERENTIAL RING GEAR REMOVAL
1) Unclamp 4 ring gear set bolt lock plates.
2) Remove 8 bolts and 4 ring gear set bolt lock plates.
NOTE:
Don't reuse lock plates.
3) Remove differential ring gear.
BEARING OUTER RACE REMOVAL
1) Remove differential side oil seal.
NOTE:
Don't reuse removed oil seal.
2) Drive out taper roller bearing outer race and washer from trans-
mission case by using special tools or like.
Special Tool
(A): 09924-74510
(B): 09924-74590
(C): 09924-84510-005
BEARING OUTER RACE INSTALLATION
1) Install bearing outer race and washer by using special tool and
hummer.
Special Tool
(A): 09924-74510
(B): 09944-68210
DIFFERENTIAL RING GEAR INSTALLATION
1) Heat differential ring gear to about 100 C (212 F) in oil bath.
2) Clean mating surfaces of differential ring gear and differential
case.
3) Install differential ring gear to differential case.
4) Install new 4 ring gear set bolt lock plates and 8 bolts and tighten
bolts to specified torque.
Tightening Torque
(a): 99 N·m (9.9 kg-m, 72.0 lb-ft)
5) Clamp bolts with lock plate securely.
AUTOMATIC TRANSMISSION 7B1-141