Suzuki Baleno Manual page 671

25) Install ring gear bearing and races on front planetary gear as-
26) Install front planetary ring gear assembly.
27) After making sure for its correct installing direction, install 2nd
28) Inspect output shaft seal ring for wear or damage, and replace
1. Output shaft seal ring
29) Install input shaft seal rings on input shaft, if replacing is re-
AUTOMATIC TRANSMISSION (3 A/T) 7B-101
sembly in following order:
i) Race (flange side up)
ii) Bearing
iii) Race (flange side down)
Refer to "ASSEMBLING UNIT" in this section for proper instal-
lation.
After installing front planetary ring gear assembly, check bear-
ing and races installed in step 25) for proper installation by
moving ring gear assembly up and down lightly with finger. If
ring gear assembly makes clear sound like "Click" when
moved up and down, bearing and races are installed in place.
But if no sound or thick one is heard, it is possible that they are
out of place. In such case, remove ring gear assembly and
check.
brake band in case.
Be careful not to bend it too much, or damage it.
NOTE:
When installing a new brake band, soak it in transmission
fluid for more than 2 hours in advance.
if necessary.
Do not expand seal ring excessively when installing.
quired.
When installing input shaft seal rings, apply grease to grooves
in input shaft before installation.
Do not expand seal ring excessively.