Front Door Assembly - Suzuki Baleno Manual

1. Rags
2. Wooden piece

FRONT DOOR ASSEMBLY

REMOVAL
1) Disconnect door harness couplers, and remove corrugation
tube from body.
1. Corrugation tube
2. Body
3. Coupler
2) Remove stopper pin upward by tapping it with hammer.
3) Using a jack, support door panel with a piece of wood placed
between jack and panel.
4) Remove door assembly by loosening hinge mounting bolts.
INSTALLATION
Reverse removal procedure for installation, and then noting the fol-
lowing instructions.
When weatherstrip is hardened, water leak may develop.
In such case, replace it with new one.
After installing, adjust door latch striker position referring to
"FRONT DOOR LOCK INSTALLATION" in this section so that
door is positioned correctly.
"A": Oil point
1. Upper hinge
2. Lower hinge
3. Door
4. Body
BODY SERVICE 9-7