Suzuki Baleno Manual page 207

3D-8 FRONT SUSPENSION
1. Coil spring lower seat
2. Small diam. spring end
1. Spring upper seat
2. Strut bracket
3. "OUT" mark
1. Strut nut 6. Bump stopper
2. Strut support 7. Dust cover
3. Bearing 8. Coil spring
4. Coil spring upper seat 9. Coil spring lower seat
5. Coil spring seat 10. Strut
2) Install coil spring lower seat and compressing coil spring, and
mate spring end with stepped part of lower seat as shown.
3) Install bump stopper and dust cover onto strut rod. For installing
direction, refer to above figure in DISASSEMBLY.
4) Pull strut rod as far up as possible and use care not to allow it
to retract into strut.
5) Install spring seat on coil spring and then spring upper seat
aligning "OUT" mark on spring upper seat and center of strut
bracket.
6) Install bearing strut support and strut nut in this sequence.
Tighten strut nut to specified torque and then apply waterproof
coating (paint or lacquer) all around nut and strut rod thread.
Tightening Torque
(a): 65 N·m (6.5 kg-m, 47.0 lb-ft)