Suzuki Baleno Manual page 590

7B-20 AUTOMATIC TRANSMISSION (3 A/T)
DIAGNOSTIC TROUBLE CODE (DTC) TABLE
A: Using scan tool for vehicle with WU-TWC
B: Using scan tool and not using scan tool for vehicle without WU-TWC
C: Driving cycles when MIL lighting for vehicle with WU-TWC
D: Driving cycles when PCM stores DTC in its memory for vehicle without WU-TWC
DTC NO.
DETECTING ITEM DETECTING ITEM
A B
– 12 Normal
Transmission range sen-
P0705 P0705 72 72
sor circuit malfunction
Output speed sensor
P0720 24
circuit malfunction
Not
Shift solenoid-A
P0751 appli-
performance or stuck off
cable
Not
Shift solenoid-B
P0756 appli-
performance or stuck off
cable
P0753 61/62 Shift solenoid-A electrical
P0758 63/64 Shift solenoid-B electrical
FAIL-SAFE TABLE
DTC No. DETECTED ITEM
Transmission range sensor
(switch) circuit malfunction
P0705
Output speed sensor (A/T
P0720
VSS) circuit malfunction
P0753 Shift solenoid-A electrical
P0758 Shift solenoid-B electrical
DETECTING CONDITION
(DTC will set when detecting:)
g No signal or multiple signals inputted with g
shifted in "D" range.
No signal inputted while running vehicle
with "D" or "2" range.
While running in "D" range, engine speed
as compared to vehicle speed higher or as compared to vehicle speed higher or
lower than specified value
Output command from PCM and output
voltage do not agree voltage do not agree.
(Solenoid circuit shorted to ground or open)
No signal PCM controls solenoids on "L" range base.
inputted
Multiple PCM controls solenoids according to following priority
signal order. L > R > D > 2 > N > P
inputted
Gear is held at 3rd gear when in "D" range and at 2nd gear when
in "2" range.
When short circuit is detected, PCM
does not output ON command to shift
solenoid until vehicle stops and selector
lever is shifted to "P" or "N" range.
–
g
FAIL-SAFE OPERATION
Gear is held at 3rd gear
when in "D" range.
Gear is not shifted to 1st
gear when in "D" range
or in "2" range.
C C D D
– –
1 driving g 1 driving g
cycle cycle
1 driving 1 driving
cycle cycle
2 driving g Not
applicable
cycles
1 driving g 1 driving g
cycle cycle