Transmission Range Switch Circuit Check - Suzuki SQ416 Service Manual

TRANSMISSION RANGE SWITCH CIRCUIT CHECK

Step
1 Transmission Range Switch Circuit Check
1) Disconnect connector from cruise control module with
ignition switch OFF.
2) Check for proper connection to cruise control module at
terminal E132-9.
3) If OK, connect ohmmeter between terminal E132-9 and
ground.
4) Check for continuity under each condition below.
Transmission range switch circuit specification
Selector lever at "P" or "N" range: Continuity
"R", "D", "2" or "L" range: Infinity
Is check result satisfactory?
2 Transmission Range Switch Check
1) Disconnect transmission range switch connector.
2) Check for proper connection to transmission range switch at
disconnected connector terminals.
3) If OK, check transmission range switch for operation
referring to "TRANSMISSION RANGE SWITCH" in
Section 7B1.
Is check result satisfactory?
Fig. for Step 1
Action
CRUISE CONTROL SYSTEM 8E-13
Yes
Transmission Go to Step 2.
range switch
circuit is OK.
"B/R" or "B/Y" Adjust or
circuit is open or replace.
short.
No