Suzuki Baleno Manual page 388

1. Brake disc
2. Screw
1. 8 mm bolt
1. Brake disc
2. Screw
REMOVE AND INSTALL DISC
REMOVAL
1) Hoist vehicle, remove wheel and pull parking brake lever.
2) Remove brake disc screws (2 pieces).
3) Release parking brake lever.
4) Follow step 2) to 8) of "REMOVAL" under "REMOVE AND
INSTALL PAD (SHOE & LINING)" in this section.
5) Pull brake disc off by using 8 mm bolts (2 pieces).
INSTALLATION
NOTE:
See NOTE at the beginning of this section.
1) Install disc to wheel hub.
2) Follow step 1) thru 7) of "INSTALLATION" under "REMOVE
AND INSTALL PAD (SHOE & LINING)" in this section.
3) Pull parking brake lever and install brake disc screws.
4) Torque rear wheel nuts to specification.
Tightening Torque
(b): 85 N·m (8.5 kg-m, 61.5 Ib-ft)
5) Upon completion of installation, perform brake test.
BRAKES 5-63