Suzuki Baleno Manual page 667

8) Using special tools (Output shaft remover and Bearing remov-
A: Notches where special
tool pushes output
shaft through bearing.
1. Output shaft
2. Rear cover
9) After engaging teeth of final gear and countershaft gear, install
10) Install 1st-reverse brake parts.
1. Damper plate
A: Convex side upward
er handle), push output shaft against rear cover side.
i) Fit 4 projections of special tool (Output shaft remover) to 4
notches A in case.
ii) Push bearing and output shaft against rear cover side by
tapping special tool (Bearing remover handle) with a ham-
mer lightly.
CAUTION:
D Do not hit output shaft directly, or shaft end will
be damaged.
D Be careful not to hammer with special tool too
hard.
Special Tool
(B): 09925-18010
(C): 09927-08210
differential assembly.
CAUTION:
D Be careful not to damage gear tooth by hitting it
with other one.
D Make sure that differential assembly is placed on
case straightly, while installing it.
D Drive in differential by giving force to side bearing
inner race through special tool (bearing installer).
Special Tool
(D): 09951-76010
i) Install damper plate to return spring assembly with convex
side upward. Use care not to install in reverse direction.
AUTOMATIC TRANSMISSION (3 A/T) 7B-97