Suzuki Baleno Manual page 837

1. Solenoid coupler
2. Output shaft speed sensor
3. Input shaft speed sensor
4. Oil filler tube
69) Clamp wiring harness of solenoid and transmission tempera-
70) Connect couplers of solenoid and install transmission temper-
1. Clamp
2. Throttle pressure
control solenoid
3. No.1 shift solenoid
4. No.2 shift solenoid
5. TCC control solenoid
71) Wipe off and clean contacting surface between case and side
72) Apply sealant to transmission case by using a nozzle as
1. Nozzle
73) Tighten transmission side cover with bolts.
1. Transmission
side cover
74) Coat new O-rings with A/T fluid.
75) Tighten the following parts (with new O-rings installed) with
ture sensor.
ature sensor to its clamp.
NOTE:
Check to make sure that couplers are connected prop-
erly. (No.1 shift solenoid-white, No.2 shift solenoid-blue
and lock-up control solenoid-yellow).
There is an interchangeability between No.1 and No.2
shift solenoids for installation.
cover.
shown in figure by such amount that its section is 1.5 mm
(0.059 in) in diameter.
"A": Sealant 99000-31230 (SUZUKI BOND NO.1216B)
Tightening Torque
·
(a): 18 N m (1.8 kg-m, 13.0 lb-ft)
NOTE:
Check to make sure that new bolts are used for bolts indi-
cated as (1) in figure.
bolts.
Solenoid coupler
Output shaft speed sensor
Input shaft speed sensor
Oil filler tube
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 Ib-ft)
AUTOMATIC TRANSMISSION 7B1-153