Suzuki Baleno Manual page 787

1. Forward clutch drum assembly
2. Transmission rear cover
INSPECTION
1) Check that sliding surfaces of discs, plates and flanges are not
worn or burnt. If necessary, replace.
NOTE:
D If disc lining is exfoliated or discolored, or part of printed
numbers ("A" section) is defaced, replace all discs.
D Before assembling new discs, soak them in A/T fluid for
at least two hours.
2) Measure height of forward clutch return spring.
Specified value: 22 mm (0.87 in.)
NOTE:
Do not apply excessive force when measuring spring
height. Perform measurement at several points.
3) Check to make sure that ball makes creaking noise when shak-
ing forward clutch piston. (i.e., check that ball is free.)
4) Check that there is no leakage from backside of oil hole "A" by
applying low pressure air.
1. Ball
REASSEMBLY
1) Coat new clutch drum oil seal rings with A/T fluid.
2) Install them to transmission rear case and forward clutch drum
subassembly.
NOTE:
D Do not spread ring ends excessively.
D Make sure that opening ends of oil seal rings are not
lined up so as to prevent fluid leakage.
3. Oil seal ring
4. Oil seal ring
AUTOMATIC TRANSMISSION 7B1-103