Suzuki Baleno Manual page 503

1. Drive shaft joint
2. Screwdriver
1. Drive shaft 3. Bolt
2. Center bearing support
MANUAL TRANSMISSION (J18 ENGINE MODEL) 7A1-5
UNIT REPAIR OVERHAUL
DISMOUNTING OF TRANSMISSION
UNDER HOOD
1) Disconnect battery ground cable.
2) Remove clutch operating cylinder from T/M with hose still at-
tached.
3) Remove gear control cables.
4) Remove select cable lever with bracket.
5) Undo wiring harness clamps and couplers.
6) Remove ground cable from T/M.
7) Remove starting motor taking out its 2 bolts. Starting motor
plate should also come down.
8) Remove exhaust manifold cover.
9) Remove transmission fastening bolt and nut.
10) Detach P/S oil tank from bracket.
11) Remove air cleaner.
12) Detach engine RH mounting from body.
ON LIFT
1) Drain transmission oil.
2) Remove engine under covers.
3) Remove exhaust No.1 pipe.
4) Remove clutch housing lower plate.
Disconnect stabilizer joint from suspension arm.
5) Remove ball stud bolt from right and left knuckles, then discon-
nect each suspension arm.
6) By using large size screwdrivers, pull out drive shaft joints at
differential side so as to release snap ring fitting of joint (for LH
drive shaft).
7) Remove center bearing support bolts and pull out center drive
shaft from differential gear (for RH drive shaft).
8) Remove engine rear mounting stiffener.
9) Remove transmission to engine bolt and nut.
10) Remove engine rear mounting bracket bolts.
11) Lower vehicle and support transmission with transmission
jack.