Suzuki Baleno Manual page 231

3E-8 REAR SUSPENSION (2WD VEHICLE)
REMOVE AND INSTALL STABILIZER BAR
AND/OR BUSHINGS (IF EQUIPPED)
REMOVAL
CAUTION:
To avoid the risk of being burned, start your work after the
exhaust system has cooled down.
1) Hoist vehicle and remove rear wheels.
2) Remove stabilizer link nuts. Then remove stabilizer joints from stabi-
lizer bar. When loosening link nut and joint nut, hold stud with wrench.
3) Remove stabilizer mount brackets.
4) Remove stabilizer bar.
INSTALLATION
1) Loosely assemble all components in reverse order of removal.
2) With painted mark on stabilizer bar and end face of mount bushing
aligned, tighten mount bracket bolts to specified torque.
NOTE:
If painted mark has faded out, align the vehicle center and the
center of stabilizer bar.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
3) Tighten each nut to specified torque.
When tightening, hold stud with wrench.
Tightening Torque
(b): 50 N·m (5.0 kg-m, 36.5 lb-ft)
1. Mount bush
2. Painted mark
1. Stabilizer bar
2. Mount bush
3. Mount bracket
4. Joint
5. Joint nut
6. Link nut
7. Mount bolt