Suzuki Baleno Manual page 874

7C1-18 CLUTCH (HYDRAULIC TYPE)
1. Input shaft
1. Release shaft
4) Slightly apply grease to input shaft, then join transmission as-
sembly with engine. Refer to "REMOUNTING" under "UNIT RE-
PAIR OVERHAUL" in Section 7A.
"A": GREASE 99000-25210 (SUZUKI SUPER GREASE I)
NOTE:
When inserting transmission input shaft to clutch disc,
turn crankshaft little by little to match the spline mesh.
CLUTCH RELEASE SYSTEM
REMOVAL
1) Remove release arm by loosening its bolt.
2) Take out release bearing by turning release shaft.
3) Drive out No.2 bush by using special tool and hammer.
Release shaft seal will also be pushed out.
Special Tool
(A): 09922-46010
4) Remove release shaft.
5) Pull No.1 bush out by using special tools.
Special Tool
(A): 09925-46010
(B): 09930-30104