Suzuki Baleno Manual page 766

7B1-82 AUTOMATIC TRANSMISSION
1. Exhaust No.1 pipe mounting nuts
1. Drive plate bolt
2. Transmission case
3. Cylinder block
DISMOUNTING
<G16 engine model>
1) Disconnect negative cable at battery and transmission.
2) Disconnect coupler for solenoids, vehicle speed sensor (for
speedometer), shift lever switch, forward clutch cylinder revo-
lution sensor and output shaft speed sensor.
3) Undo wiring harness clamps.
4) Disconnect select cable from transmission.
5) Drain cooling system.
6) Remove water intake pipe.
7) Remove transmission-to-engine bolts.
8) Remove starting motor.
Starting motor plate should also come down.
9) Remove exhaust manifold cover.
10) Remove exhaust manifold to No.1 pipe nuts.
11) Support engine to prevent one from being declined excessive-
ly at removal of mounting supports.
12) Check around transmission for any other parts required to be
removed or disconnected for dismounting of transmission and
remove or disconnect whatever necessary.
13) Drain transmission fluid.
14) Remove engine under covers.
15) Disconnect oil cooler hoses.
16) Remove mounting member.
17) Remove exhaust pipe.
18) Remove stiffener.
1. Stiffener
19) Remove transmission housing lower plate.
20) Holding drive plate with a large size screwdriver against rota-
tion, remove drive plate bolts.