Transmission Range Sensor Check; Output Shaft Speed Sensor Check - Suzuki Swift User Manual

1. PCM coupler disconnected
AUTOMATIC TRANSMISSION (3 A / T) (VEHICLE WITH WU-TWC) 7B-39

TRANSMISSION RANGE SENSOR CHECK

Check transmission range sensor referring to Step 2 of DTC P0705
Flow Table.

OUTPUT SHAFT SPEED SENSOR CHECK

1) Turn OFF ignition switch.
2) Disconnect coupler(s) from powertrain control module.
3) Bring ohmmeter probes in touch with coupler terminals from har-
ness side.
4) Check resistance of output shaft speed sensor.
Resistance between terminals
C03-2 and C03-13
(For G10 engine model)
C03-2 and C03-8
(For G13 engine model)
Resistance between terminal
and ground
If resistance are out of specification, check wire harness and
connector for open or short and output shaft speed sensor itself
for resistance.
If resistance are within above specifications, proceed to next
step.
5) Visually check output shaft speed sensor and counter shaft gear
for the following:
D No damage
D No foreign material attached
D Correct installation
If any malfunction is found, clean, repair or replace.
: 100 – 300 Ω
: 1 MΩ or more