Suzuki Baleno Manual page 1000

09931-76011
Suzuki scan tool (Tech 1A kit)
09931-76030
16 / 14 pin DLC cable
PROCEDURE AFTER ECM/PCM
REPLACEMENT
When ECM/PCM was replaced, including when replaced because
rechecking by using a known-good ECM/PCM was necessary
during trouble diagnosis, register ECM/Immobilizer Control Mod-
ule code in ECM/PCM by performing following procedure.
1) Perform Steps 1) and 2) described in "How to register ignition
key" section. And then turn ignition switch ON.
2) Using Suzuki scan tool, register ECM/Immobilizer Control Module
code in ECM/PCM by executing "RECORD ECU (RECORD
ECM/PCM/ICM)" command in SELECT MODE menu.
NOTE:
For operation procedure of Suzuki scan tool, refer to
TECH1 operator's manual.
3) [Vehicle not equipped with immobilizer indicator lamp]
Make sure that malfunction indicator lamp lights when ignition
switch is turned OFF once and then ON.
[Vehicle equipped with immobilizer indicator lamp]
Make sure that immobilizer indicator lamp lights when ignition
switch is turned OFF once and then ON.
SPECIAL TOOLS
1. Storage case
2. Operator's manual
3. Tech 1A
4. DLC cable
(14 / 26 pin, 09931-76040)
5. Test lead/probe
6. Power source cable
7. DLC cable adapter
8. Self-test adapter
NOTE:
Use this cable only with im-
mobilizer cartridge of ver-
sion 1.1 or more.
Use of this cable with 96
immobilizer cartridge will
disable 96 immobilizer car-
tridge from operating prop-
erly.
IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED) 8G-35
Immobilizer cartridge of
version 1.1 or more
Mass storage cartridge of
version 1.5 or more