Suzuki Baleno Manual page 851

7C-8 CLUTCH (CABLE TYPE)
1. Flywheel bolt
1. Clutch cover bolt
INSTALLATION
NOTE:
Before assembling, make sure that flywheel surface and pres-
sure plate surface have been cleaned and dried thoroughly.
1) Install flywheel to crankshaft and tighten bolts to specification.
Special Tool
(A): 09924-17810
Tightening Torque
(a): 78 N·m (7.8 kg-m, 56.5 lb-ft)
2) Using special tool, install input shaft bearing to flywheel.
Special Tool
(B): 09925-98210
3) Aligning clutch disc with flywheel center by using special tool,
install clutch cover and bolts.
Then tighten bolts to specification.
NOTE:
D While tightening clutch cover bolts, compress clutch
disc with special tool (clutch center guide) by hand so
that disc is centered.
D Tighten cover bolts little by little evenly in diagonal or-
der.
Special Tool
(A): 09924-17810
(C): 09923-36330
Tightening Torque
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)