Suzuki Baleno Manual page 658

7B-88 AUTOMATIC TRANSMISSION (3 A/T)
1. Side bearing (L)
2. Bearing puller
1. Differential side bearing (R)
2. Bearing puller
1. Differential case
2. Differential gear
3. Differential pinion
shaft
1. Differential side bearing (L)
2. Differential case
Disassembly
1) Remove differential side bearing (L).
Use special tool and puller for its removal.
Special Tool
(A): 09925-88210
2) Remove final gear.
Hold differential case with soft jawed vise and remove 8 bolts
then take out final gear.
3) Remove differential side bearing (R).
Drive it out by using special tool, bearing puller and press.
Special Tool
(B): 09913-80112
4) Remove speedometer drive gear.
5) Remove side pinion shaft pin.
Use special tool and hammer for its removal.
Special Tool
(C): 09922-85811
6) Remove side pinion shaft, differential pinions with each washer,
differential gears with each washer.
Adjustment and Reassembly
Prepare replacing parts as required and proceed to reassembly.
Make sure that all parts are clean.
1) Install differential gears.
Measure and adjust thrust play referring to "DIFFERENTIAL
ASSEMBLY" in Section 7A, and then assemble them with suit-
able thrust washers.
2) Drive in side pinion shaft pin from right side till it is flush with diff.
case surface.
3) Install diff. side bearing (L). Face its seal side inward (differential
case side) and press-fit by using special tool.
Special Tool
(A): 09951-76010