3C-6 STEERING WHEEL AND COLUMN (NOT EQUIPPED WITH AIR BAG)
1. Hole cover
1. Steering column upper cover
2. Steering column lower cover
1. Junction/fuse block
COMBINATION SWITCH
REMOVAL
1) Disconnect negative battery cable.
2) Before removing this switch, remove steering wheel. Refer to
"STEERING WHEEL" earlier in this section.
3) Remove hole cover.
4) Remove steering column cover screws (3 pcs).
5) Separate upper cover and lower cover, then remove them.
6) Loosen clamp.
7) Remove band binding steering column and harness (for contact
coil and combination switch assembly).
8) Disconnect white 4-P connector (for auto cruise, optional).
9) Disconnect three connectors for combination switch wire har-
ness from junction/fuse block.