Suzuki Baleno Manual page 230

1. Strut upper nut
2. Strut support
3. Spring upper seat
4. Spring (rubber) seat
5. Bump stopper
8) Put strut support on spring upper seat.
Tighten strut upper nut to specified torque and then apply water-
proof coating (paint or lacquer) all around nut and strut rod
thread.
Tightening Torque
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
9) Loosen and remove special tool (A) from compressing coil
spring. While loosening special tool, recheck that stepped part
of spring seat and spring end are in place to each other as de-
scribed in foregoing Step 2).
Also, check to make sure that "OUT" mark on upper seat is
matched with the center of strut bracket as described in Step 7).
6. Dust cover
7. Coil spring
8. Spring lower seat
9. Strut
REAR SUSPENSION (2WD VEHICLE) 3E-7