Operation Check Of One-Way Clutches - Suzuki Baleno Manual

1. Snap ring 3. Planetary gear assembly
2. Overdrive clutch hub 4. Thrust bearing race
1. Thrust needle roller bearing

OPERATION CHECK OF ONE-WAY CLUTCHES

1) Install forward clutch assembly and overdrive/coast clutch as-
sembly to transmission rear cover.
2) Install planetary ring gear assembly to forward clutch and install
No.0 (F0) one-way clutch to planetary ring gear facing toward
front side.
3) Check to make sure that No.0 (F0) one-way clutch turns freely
when turned clockwise "A" and locks when turned counter-
clockwise "B".
4) Remove planetary ring gear assembly from forward clutch as-
sembly.
5) Turn over planetary ring gear assembly.
6) Check to make sure that No.1 (F1) one-way clutch turns freely
when turned counterclockwise "A" and locks when turned
clockwise "B".
DISASSEMBLY – No.1 (F1)
1) Remove the following parts by removing snap ring.
D Overdrive clutch hub
D Planetary gear assembly
D Two thrust bearing races
2) Pull out thrust needle roller bearing.
Reference value for bearing
Outside diameter : Approximately 83.2 mm (3.28 in.)
Inside diameter : Approximately 68.3 mm (2.69 in.)
Thickness : Approximately 2.6 mm (0.10 in.)
AUTOMATIC TRANSMISSION 7B1-113