Suzuki Baleno Manual page 721

Test result
Lower than standard
level
Higher than standard
level in "D" range
Higher than standard
level in "R" range
TIME LAG TEST
This test is to check conditions of clutch, reverse brake and fluid
pressure. "Time lag" means time elapsed since select lever is
shifted with engine idling till shock is felt.
1) With chocks placed before and behind front and rear wheels re-
spectively, depress brake pedal.
2) Start engine.
3) With stop watch ready, shift select lever from "N" to "D" range
and measure time from that moment till shock is felt.
4) Similarly measure time lag by shifting select lever from "N" to "R"
range.
Specification for time lag Specification for time lag
NOTE:
D When repeating this test, be sure to wait at least minute
after select lever is shifted back to "N" range.
D Engine should be warmed up fully for this test.
Test result
When "N" "D" time
lag exceeds specifi-
cation
When "N" "R" time
lag exceeds specifi-
cation
AUTOMATIC TRANSMISSION 7B1-37
Possible cause
D Faulty engine output
D Defective torque converter
D Low line pressure
D Malfunctioning one-way clutch No.0
and/or coast clutch
D Malfunctioning forward clutch
D Malfunctioning one-way clutch No.1
D Low line pressure
D Malfunctioning reverse clutch
D Malfunctioning 1st/reverse brake
"N" "D" Less than 0.7 sec.
"N" "R" Less than 1.2 sec.
Possible cause
D Low line pressure
D Worn forward clutch
D Low line pressure
D Worn direct clutch
D Worn 1st/reverse brake