Suzuki Baleno Manual page 359

5-34 BRAKES
1. Pin
2. Clip
3. Caliper
4. Disc
1. Parking brake
cable
2. E-ring
3. Parking brake cable bracket
4. Disc
1. Parking brake cable
2. Clamp
3. Fuel tank
4) Disconnect cable from parking brake lever by referring to steps
1), 2) and 3) of "REMOVAL" under "REMOVE AND INSTALL
PARKING BRAKE LEVER" in this section.
5) Remove cable from vehicle body.
[For vehicles with rear disc brake]
1) Disconnect cable from parking brake lever by referring to steps
1), 2) and 3) of "REMOVAL" under "REMOVE AND INSTALL
PARKING BRAKE LEVER" in this section.
2) Hoist vehicle and remove rear wheels.
3) Remove parking brake cable clip and pin at rear caliper.
4) Remove parking brake cable bracket from caliper.
5) Remove parking brake cable E-ring.
6) Remove parking brake cable clamps.
7) Remove parking brake cable.
INSTALLATION
NOTE:
See NOTE at the beginning of this section.
[For vehicles with rear drum brake]
Install parts in reverse order of removal procedure, noting the fol-
lowing.
D Install brake cable stopper ring to brake back plate securely as
1. Brake back plate
shown in figure.
2. Cable stopper ring
3. Brake cable