Power Steering (P/S) Pump - Suzuki Baleno Manual

3B1-4 POWER STEERING (P/S) SYSTEM

POWER STEERING (P/S) PUMP

The power steering pump is a vane type and is driven by the V-ribbed belt from the crankshaft.
[1.3 L and 1.6 L engine models]
Model
Hydraulic pressure control
Power steering pressure switch
[1.8 L engine model]
Vehicle equipped with A/C
[1.3 L and 1.6 L engine models]
7500 kPa (75 kg / cm
Relieved pressure
[1.8 L engine model]
8500 kPa (85 kg / cm
Flow control valve
Control device Control device
Relief valve
Switch turns on (closes) when the pressure is higher than
3100 – 3900 kPa (31 – 39 kg/cm
ECM uses this signal for idle speed control.
1. Suction connector
2. O-ring
3. Pressure switch
4. Flow control valve
5. Spring
6. Plug
7. Pump cover
8. Cam ring
9. Vane
10. Rotor
11. Snap ring
12. Side plate
13. Pulley (pump shaft)
14. Oil seal
15. Pump body
16. Flow control valve assembly
Vehicle without A/C
Vane type
2
or 1067 psi)
2
or 1209 psi)
2
, 441 – 554 psi).
(Relief valve)
1. P/S pump pulley
2. A/C compressor pulley
3. Tensioner pulley
4. Crankshaft pulley
5. Water pump pulley
6. Generator pulley