Suzuki Baleno Manual page 945

8-48 BODY ELECTRICAL SYSTEM
OFF
ON
1. Limit Switch
2. Sliding roof drive coupler
1. Sliding roof drive gear assembly
2. Limit switch 2
3. Limit switch 1
1. Sliding roof drive gear assembly coupler
2. Stopper
3. Sliding roof drive gear coupler terminals
4. Terminal lock
5. Thin steel rod
6. Pull out while unlocking
7. Sliding roof drive gear assembly
LIMIT SWITCH 1 AND LIMIT SWITCH 2
1) Remove limit switch from sliding roof drive gear assembly and
check continuity between terminal when limit switch is ON and
OFF.
SLIDE SWITCH
C3
ON
OFF
SLIDING ROOF CONTROL RELAY
1) Remove sliding roof drive gear assembly. Refer to Section 9 of
this manual for details.
2) Remove limit switch 1 and limit switch 2 from sliding roof drive
gear assembly.
3) Disconnect sliding roof drive gear assembly coupler from slid-
ing roof sub wire.
4) Pull out terminal C3, C5 and C6 from sliding roof drive gear as-
sembly coupler. To pull terminals out, first unlock stopper up-
ward, then pull out wires (terminals) gently while unlocking the
terminal lock.
Terminals C3, C5 and C6 are the limit switch wires.
TILT SWITCH
C6 C3 C5