Suzuki Baleno Manual page 240

1. E ring 2. Brake hose bracket
1. Brake pipe
2. Wheel cylinder 3. Bleeder plug cap
1 Knuckle 3. No.2 control rod
2 No.1 control rod 4. Trailing rod
1. Strut bracket bolt & nut 2. Knuckle
REMOVE AND INSTALL KNUCKLE
REMOVAL
1) Hoist vehicle and remove wheel hub referring to WHEEL HUB
REMOVAL of SECTION 3E or 3E1.
2) Remove E ring securing brake hose.
3) Disconnect brake pipe from wheel cylinder and put wheel cylin-
der bleeder plug cap onto pipe to prevent fluid from spilling.
4) Remove ABS wheel speed sensor from knuckle, if equipped.
5) Remove brake back plate from knuckle.
1. Back plate
2. Plate bolt
6) Loosen control rod outer bolts, trailing rod rear bolt and strut
bracket nuts.
7) Disconnect control rods (No.1 and No.2) from knuckle.
8) Disconnect trailing rod from knuckle.
9) Remove knuckle from strut.
REAR SUSPENSION (2WD VEHICLE) 3E-17