Suzuki Baleno Manual page 214

3) Connect tie-rod end to knuckle and tighten tie-rod end castle nut
to specified torque.
Install new split pin.
4) For installation procedures following the above, refer to Steps
2) – 9) in WHEEL HUB INSTALLATION of this section.
Split pin
Tightening Torque
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
(b): 28 N·m (2.8 kg-m, 20.5 lb-ft)
(c): 45 N·m (4.5 kg-m, 33.0 lb-ft)
(d): 60 N·m (6.0 kg-m, 43.5 lb-ft)
(e): 90 N·m (9.0 kg-m, 65.0 lb-ft)
FRONT SUSPENSION 3D-15
1. Strut
2. Strut bracket nut
3. Tie rod end
4. Ball stud nut
5. Knuckle
6. Tie rod end castle nut
7. Ball stud
8. Stabilizer bar
9. Stabilizer bar
10. Joint nut
11. Link nut