Suzuki Baleno Manual page 712

7B1-28 AUTOMATIC TRANSMISSION
DIAGNOSTIC TROUBLE CODE (DTC) TABLE
A: Using scan tool for vehicle with WU-TWC
B: Using scan tool for vehicle without WU-TWC and not using scan tool
C: Driving cycles when MIL lighting and "O/D OFF" lamp flashing for vehicle with WU-TWC
D: Driving cycles when "O/D OFF" lamp flashing for vehicle without WU-TWC
(MIL lighting is not applicable to vehicle without WU-TWC)
DTC NO.
DETECTING ITEM DETECTING ITEM
A B
Transmission range sen-
P0705 34
sor circuit malfunction
*1
Transmission fluid tem-
36
P0710 P0710 perature sensor circuit perature sensor circuit
*1
malfunction
38
Input/Turbine speed sen-
sor (forward clutch cylin-
P0715 37
der revolution sensor) cir-
cuit malfunction
Output speed sensor (A/T
P0720 31
VSS) circuit malfunction
*2 Engine speed input circuit
P0725
35 malfunction
Torque converter clutch
*2
P0741 system performance or
29
stuck off
25
Torque converter clutch q
P0743 P0743
system electrical
26
41
Pressure control solenoid Pressure control solenoid
P0745
malfunction
42
*2 Shift solenoid-A (No.1)
P0751
17 performance or stuck off
21
Shift solenoid-A (No.1)
P0753 P0753
electrical
22
*2 Shift solenoid-B (No.2)
P0756
28 performance or stuck off
DETECTING CONDITION
(DTC will set when detecting:)
"D" and another range signals are inputted
simultaneously.
No signal is inputted while running at higher
than specified vehicle speed.
Voltage at sensor terminal of TCM is high.
(sensor circuit open)
Voltage at sensor terminal of TCM is low.
(sensor circuit shorted to ground)
No sensor signal is inputted while output
speed sensor (A/T VSS) signal is inputted.
No sensor signal is inputted while input
shaft speed sensor (forward clutch cylinder
revolution sensor) signal is inputted.
No engine speed signal is inputted while
engine running. (engine coolant temp. sig-
nal is inputted properly)
TCC is not locked up while TCC solenoid
ON is commanded.
TCC is locked up while TCC solenoid OFF
is commanded.
Voltage at solenoid terminal of TCM is high
while solenoid OFF is commanded. (sole-
noid circuit open)
Voltage at solenoid terminal of TCM is low
while solenoid ON is commanded. (sole-
noid circuit shorted to ground)
No electric current flows. (circuit open)
Excessive electric current flows. (circuit
short)
Actual gear position (ratio) does not agree
with gear position (2nd or 3rd) commanded
from TCM to A/T.
Voltage at solenoid terminal of TCM is high
while solenoid OFF is commanded. (sole-
noid circuit open)
( )
Voltage at solenoid terminal of TCM is low
while solenoid ON is commanded. (sole-
noid circuit shorted to ground)
Actual gear position (ratio) does not agree
with gear position (3rd or 4th) commanded
from TCM to A/T.
C C D D
*3
1 driving
1 driving
cycle
cycle
*3 *3
2 driving 2 driving 2 driving 2 driving
cycles cycles
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
2 driving Not
cycles applicable
2 driving Not
cycles applicable
1 driving g 1 driving g
cycle cycle
1 driving 1 driving 1 driving 1 driving
cycle cycle
2 driving Not
cycles applicable
1 driving g 1 driving g
cycle cycle
2 driving Not
cycles applicable