Clutch Pedal - Suzuki Baleno Manual

1. Clutch pedal arm
2. Clutch master cylinder clevis
3. Clevis lock nut
4. Cylinder push rod
5. Pedal stopper bolt
6. Dash panel
7. Floor carpet
8. Clevis pin
ON-VEHICLE SERVICE
MAINTENANCE SERVICE

CLUTCH PEDAL

Clutch Pedal Free Height "A"
1) Check "A" for conformance to below specification.
Clutch pedal height "A"
Left hand steering vehicle
Right hand steering vehicle : 202 – 212 mm (7.95 – 8.35 in.)
2) If "A" is not within specification, adjust it by loosening clevis lock
nut and turning push rod.
3) Be sure to tighten lock nut to specification after adjustment.
Clutch Pedal Distance "B"
1) Depress clutch pedal till pedal arm contacts stopper bolt and
measure height "B" as shown in the left figure and check it for
conformance to below specification.
Clutch pedal distance "B": 118 – 128 mm (4.65 – 5.04 in.)
2) If "B" is not within specification, correct it by adjusting height of
stopper bolt.
Clutch Pedal Free Travel "C"
1) Depress clutch pedal, stop the moment clutch resistance is felt,
and measure how much pedal has moved (clutch pedal free
travel) as represented by "C" in the left figure. Then check its
conformance to below specification.
Clutch pedal free travel "C": 15 – 20 mm (0.59 – 0.79 in.)
2) If "C" is not within specification, check pedal arm and master cyl-
inder and replace defective part.
CLUTCH (HYDRAULIC TYPE) 7C1-5
: 191 – 201 mm (7.52 – 7.91 in.)