Suzuki Baleno Manual page 673

1. Transmission case end surface
2. Direct clutch drum
3. Input shaft
4. Input shaft flange
A: Bolt with star-shaped recess in head
B: Install clamp for wiring harness
C: Install clamp for select cable
34) Check for correct installation of each component parts as fol-
lows.
After installing input shaft, check to make sure that each com-
ponent is installed properly according to the following descrip-
tion.
Place straightedge on transmission case end surface and
measure the distance "b" by using vernier. For the distance "b",
subtract the width of straightedge from vernier reading. If mea-
sured distance "b" is within following specification, it means
that component parts other than direct clutch are installed
properly.
If out of specification, remove input shaft with direct clutch and
reinstall them properly.
Distance "b": 49.82 – 51.06 mm (1.962 – 2.010 in.)
35) Align hole in second brake band with case pin hole and insert
second brake band pin.
Apply fluid to brake band pin before installation.
36) Install case gasket and transmission case housing.
Use new gasket. Install gasket using care so that it will not pro-
trude inside.
37) Among 14 bolts of case housing bolts, 3 bolts have star-
shaped recess in their heads.
Install these 3 bolts in such positions as shown by A in figure
after applying sealant to their threads. Do not apply thread
locking compound to housing bolts. Tighten case housing
bolts to specification.
"B": SUZUKI BOND No.1215, 99000-31110
Tightening Torque
(f): 20 N·m (2.0 kg-m, 14.5 Ib-ft)
AUTOMATIC TRANSMISSION (3 A/T) 7B-103