Suzuki Baleno Manual page 166

1. Steering shaft nut
2. Pad
1. Steering wheel 2. Steering shaft nut
1. Steering shaft nut
2. Pad
STEERING WHEEL AND COLUMN (NOT EQUIPPED WITH AIR BAG) 3C-5
For 4-spoke type
REMOVAL
1) Disconnect negative battery cable.
2) Remove pad screw.
3) Remove pad by pulling it upward and disconnect horn harness.
4) Remove steering shaft nut.
5) Make alignment marks on steering wheel and shaft for a guide
during reinstallation.
3. Horn harness
4. Pad screw
6) Remove steering wheel with special tool.
Special Tool
(A): 09944-36011
INSTALLATION
1) Install steering wheel onto shaft, aligning alignment marks on
them.
2) Tighten steering shaft nut to specified torque.
Tightening Torque
(a): 33 N·m (3.3 kg-m, 23.5 Ib-ft)
3) Connect horn harness and install pad.
4) Tighten pad screw.
3. Horn harness
4. Pad screw
5) Connect battery negative cable.