Suzuki Baleno Manual page 886

7F-8 REAR DIFFERENTIAL
1. Side washer
2. Pinion washer
3. Pinion shaft
4. Side gear
5. Pinion
6. Differential case
INSPECTION
D Check flange for wear or damage.
D Check bearings for wear or discoloration.
D Check differential carrier for cracks.
D Check drive bevel pinion and bevel gear for wear or cracks.
D Check side gears, pinion gears and pinion shaft for wear or dam-
age.
D Check side gear spline for wear or damage.
ADJUSTMENT AND REASSEMBLY
Judging from faulty conditions noted before disassembly and what
is found through visual check of bearing and gear tooth etc. after
disassembly, prepare replacing parts and proceed to reassembly
according to procedures as described below.
CAUTION:
D Bevel gear and pinion must be replaced as a set when
either replacement becomes necessary.
D When replacing taper roller bearing, replace as inner
race & outer race assembly.
DIFFERENTIAL CARRIER
For press-fitting bevel pinion bearing outer races by using special
tools as shown in left figure.
Special Tool
(A): 09924-74510
(B): 09951-16090
1. Differential carrier
DIFFERENTIAL CASE
1) After applying differential oil to side gear, pinions, pinion shaft
and washers, install them in differential case.
NOTE:
Used left and right differential side washers are not inter-
changeable.